U.S.. FCC Notices. FCC ID: BKMAE-H714RX. Contains FCC ID: BKMAE-E207. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that ...
WirelessHD model: H714A Contains Bluetooth module model: DBUB-E207 This document provides safety instructions and describes the specifications. Read this document carefully before use to ensure your safety and product performance.
U.S.
Canada Industry Canada (IC) Notices IC: 1052D-H714RX Contains IC: 1052D-E207 This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
FCC Notices FCC ID: BKMAE-H714RX Contains FCC ID: BKMAE-E207 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter product procedures. Properly shielded cables must be used for connections to LCD Projector in order to meet FCC emission limits. The cable for peripheral with a ferrite core must be used for RF interference suppression. IMPORTANT NOTE: FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Epson America, Inc. MS: 3-13 3840 Kilroy Airport Way Long Beach, CA 90806 Tel :562-290-5254
Printed in China
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter except in accordance with IC multi-transmitter product procedures. Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en association avec une autre antenne ou transmetteur. IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. This equipment is not permitted for used on aircraft or satellites.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will n
The power door locks will cycle when you have successfully entered ... If programming has failed, repeat this procedure from the beginning. ... Changes or modifications not expressly approved by Dorman Products Inc. could void the user's ...
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
Programming Instructions: 1) Turn vehicle ignition key to ON position, without starting engine (Key-On Engine-Off - Position "1"). 2) Insert Programmer into OBD connector DLC port ( - located under steering column, near pedals). Green LED should turn
Le present appareil est conforme aux CNR d'Industrie Canada app licables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et. (2) l'utilisateur de l
18 juil. 2016 - may lead to the violation of FCC/IC limit and is prohibited. Installation procedure. Please refer to user's manual for the detail. w Warning: Please carefully select the installation position and make sure that the final output power
Make sure the power door locks to confirm you are in the programming mode. 7) Press the LOCK ... button to confirm that the system has accepted the remote.
Google Playâ¢. Google Chromeâ¢. Google Play is a trademark of Google Inc. The Google Play store allows you to download apps, music, movies, and games ...
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or ... For telecommunication type connectors and terminals not used for connectio
When end-user instructions are required, as in the case of this product, the ... manual to ensure continued FCC and Industry Canada regulatory compliance.
14 juil. 2014 - Pick the Local Package Directory (this is the download cache directory). 5. ... Confidential. 9-1. Run normal F/W. æå½±çç·¨è 19. Open OS terminal and set USB comport (reference to page9 ), set baud- rate as 115200 off off ... Th
power off. Play/pause music. Tap the Multi-function button. Answer/end call ... Activate Siri/Google. Now/Cortana. Tap the Voice button, when not on a call.
The presence of the DMBDI/U inside a control unit is optional and .... At least one must be deleted or unlock the memory. ... to be deleted until the module flashes.
3 juin 2016 - However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and o
13 juin 2013 - Reinforced Concrete. Iron. Reinforced Concrete. Nylon Insulation ring. (included in installation set). Retainer ring (not included in installationset).
Pairing between Shutter Line and your Smartphone. Make sure Bluetooth is âONâ in your Smartphone. Press and hold the âPairingâ button until LED in Green is blinking. Check the âCamera Shutter 3.0â in the list of detected devices. Tap the
RISK OF FIRE OR ELECTRIC SHOCK WHICH MAY RESULT IN PERSONAL INJURY OR DEATH. Use as instructed. Safe Usage Guidelines for Products. - Install in accordance with the manufacturer's instructions. - Maintain a minimum distance of at least 6 inches (15 c
