4-Door vehicle: REMOVE REAR DOOR SCUFF PLATE. Insert a screwdriver between the rear door scuff plate and body to pry it out. HINT: Tape the screwdriver ...
REMOVAL NOTICE: If the wiring connector of the seat belt pretensioner is disconnected with the ignition switch at ON or ACC, diagnostic trouble codes will be recorded. Never use seat belt pretensioner from another vehicle. When replacing parts, replace them with new parts. 1. REMOVE FRONT DOOR SCUFF PLATE Insert a screwdriver between the front door scuff plate and body to pry it out. HINT: Tape the screwdriver tip before use.
H11005
2.
H13437
4-Door vehicle: REMOVE REAR DOOR SCUFF PLATE Insert a screwdriver between the rear door scuff plate and body to pry it out. HINT: Tape the screwdriver tip before use. 3. 2-Door vehicle: REMOVE FRONT DOOR OPENING TRIM Remove the front door opening trim except cowl side trim part. 4. 2-Door vehicle: REMOVE REAR SEAT CUSHION (See page BO-101 or BO-106 ) 5. 2-Door vehicle: REMOVE REAR SEATBACK (See page BO-101 or BO-106 )
6. (a) (b) (c) 8 Clips 3 Clips
H12876
2-Door vehicle: REMOVE QUARTER TRIM Remove the bolt and rear seat outer belt floor anchor. w/ Split type rear seat: Remove the bolt and seatback hinge. Insert a screwdriver between the quarter trim and body to pry it.
HINT: Tape the screwdriver tip before use.
2002 ECHO (RM884U)
Author:
Date:
1434
BO-1 15 BODY
7. (a)
H13438
-
SEAT BELT PRETENSIONER
4-Door vehicle: REMOVE CENTER PILLAR LOWER GARNISH Using a screwdriver, remove the front seat outer belt floor anchor cover cap.
HINT: Tape the screwdriver tip before use. (b) Remove the bolt and front seat outer belt floor anchor. (c) Insert a screwdriver between the garnish and body to pry it out. HINT: Tape the screwdriver tip before use.
8. (a)
2-Door vehicle: REMOVE ROOF SIDE INNER GARNISH Using a screwdriver, open the seat belt shoulder anchor cover cap.
HINT: Tape the screwdriver tip before use. (b) Remove the bolt and front seat outer belt shoulder anchor. H11009
(c) (d)
7 Clips 2 Clips
Remove the clip. Insert a screwdriver between the roof side inner garnish and body to pry it out.
HINT: Tape the screwdriver tip before use.
H12877
9.
2-Door vehicle: REMOVE CENTER PILLAR TO FLOOR REINFORCEMENT Remove the 5 bolts, 2 nuts and center pillar to floor reinforcement.
H12902
2002 ECHO (RM884U)
Author:
Date:
1435
BO-1 16 BODY
H11018
-
SEAT BELT PRETENSIONER
10. REMOVE FRONT SEAT OUTER BELT CAUTION: Never disassemble the front seat outer belt. NOTICE: When removing the retractor of front seat outer belt, take care not to pull the seat belt pretensioner wire harness. (a) 4-Door vehicle: Using a screwdriver, remove the seat belt shoulder anchor cover cap. HINT: Tape the screwdriver tip before use. (b) 4-Door vehicle: Remove the bolt and front seat outer belt shoulder anchor.
(c)
Disconnect the pretensioner connector as shown in the illustration. CAUTION: When removing the seat belt pretensioner, work must be started 90 seconds after the ignition switch is turned to the ”LOCK” position and the negative (-) terminal cable is disconnected from the battery. (d) Remove the 2 bolts and retractor of front seat outer belt. H11075
This invention relates to a safety belt for use in ve- 10 the chest of the driver and down to ... side of the seat of the vehicle a floor over the shoulder it may pass under the arm of the per- ... an unfastening device of the belt in detached positi
Note: This information is not binding, therefore it must be considered only an example for installation purposes ... as per the instructions given on the product installation manual. ... Diagram for perimetrical connection with separated lines on.
INSPECT DRIVE BELT DEFLECTION. (a) Using a belt tension gauge, apply load of. 98 N (10 kgf, 22 lbf). (b) Measure drive belt deflection. Drive belt deflection:.
0.30m de VELCROº de 2cmy Pegamento paratela. Opcional: Piedrasacrifica de 1-3cm y Pegamento para joyas o Plumas y Pegamento paratela. D, E, F: 0,50m de Elástico de 6mm. Opcional: Piedras acrilicas de 13cmy Pegamento para joyas o Plumas, Pompóns o
21⢠Retirer l'ailette de la housse par le dessous de la housse, comme sur la figure. Tirer la housse par le haut, en la faisant passer à travers la ceinture.
2. After placing the base on the vehicle seat, squeeze load leg adjust button to ...... NÃO utilize outros artigos do que os forros recomendados para o interior.
DRIVE BELT. INSPECTION. INSPECT DRIVE BELT. (a) Visually check the belt for excessive wear, frayed cords, etc. If any defect has been found, replace the ...
Old Wives Tale, Belt Drive. Reprinted from CONTACT! Magazine, issue #72. Written by Dan Horton. Issue #70 includes an article about a marvelous scale P-51 ...
PLTWDDD SEAT. Gen lee used en ell my designs . . . Adjustheelrengle et thet rte net speeifir ï¬xed seeting. 5%th best cumfurtl. Eestrte melre, inexpensive, The" ...
"A belt-driven PSRU drive isolates the torsional vibrations coming from the propeller." I contend ... An example might be a flap or standing wave in the belt spans.
The leather may be either oak-tanned or mineral salt-tanned e.g. chrome-tanned. In order to increase the thickness of belt, the strips are cemented together.
Introduction. 2. Selection of a Belt Drive. 3. Types of Belt Drives. 4. Types of Belts. 5. Material used for Belts. 6. Working Stresses in Belts. 7. Density of Belt ...
20.4 Advantages and Disadvantages of V-belt Drive over Flat Belt Drive. Following are ...... The hemp ropes are suitable only for hand operated hoisting machinery and as tie ropes for lifting tackle ..... Over head and gantry cranes. 6. 300 â 600 .
Seat valves series D4S are designed for directional control functions. A large variety ... 2) Springs 2, 3, 4 and 6 only. Subplate mounting ... Ext. PD from cap. â. 6.
individual hydraulic solutions for nominal flow up-to 600 ... Pilot oil line in body .... Fluid. Hydraulic oil as per DIN 51524...525. Fluid temperature. [°C] -20...+80.
20.4 Advantages and Disadvantages of V-belt Drive over Flat Belt Drive. Following are ...... The hemp ropes are suitable only for hand operated hoisting machinery and as tie ropes for lifting tackle ..... Over head and gantry cranes. 6. 300 â 600 .
the event of a crash than a single shoulder harness can. Companies such as B.A.S. Inc. (www. ... 96 OCTOBER 2009 maintenance. & restoration taken out of the ...
NBR. 5. FPM. 3) Position control for D5S08/10 only. Spring 2 or 4. Spool A and sleeve 3. Options ... AC: up to 7200, DC: up to 16000 switchings/hour. Solenoid ...
the largest effect for chest deflection coming from the load limiter, but for V*C, .... Spine. 0,8. -. 2,8. 0,5. Legs. 3,2. 2,4. 7,0. 2,8. Sum. 23,8. 6,4. 41,5. 13,4. Table 1: ...