On one side (front scheme), the four standard connection terminals for bulbs; two bulbs. (LAMP 1 and 3) installed in room #1 and another two bulbs (LAMP 2 and ...
The FLIP4 controller is used to connect 4 lights to 2 ballasts which share the operating time. On one side (front scheme), the four standard connection terminals for bulbs; two bulbs (LAMP 1 and 3) installed in room #1 and another two bulbs (LAMP 2 and 4) installed in the room #2.
LAMP / LAMPE
LAMP / LAMPE
On the other side (back sheme), two 6 ft cords with standard plugs for ballast outlets (BALLAST 1 and 2) and one 120Vac (TIMER 120Vac) power cord for a 24hrs timer (sold separately). See scheme on next page. Le contrôleur FLIP4 sert à connecter 4 ampoules à 2 ballasts qui se partagent le temps d’utilisation. D’un côté (schéma face), les quatre bornes standards de connections pour ampoules; deux ampoules (LAMP 1 et 3) installées dans la salle #1 et deux autres ampoules (LAMP 2 et 4) installées dans la salle #2. De l’autre côté (schéma dos), deux cordons d’une longueur de 6 pieds avec prises standards pour des sorties de ballasts (BALLAST 1 et 2) et un cordon d’alimentation 120Vac (TIMER 120Vac) pour une minuterie 24 heures (vendue séparément). Voir shéma page suivante.
ROOM #1 / SALLE #1 ROOM #2 / SALLE #2
LAMP / LAMPE
LAMP / LAMPE
OPERATING / FONCTIONNEMENT Each ballast supplies one bulb in room #1 and one bulb in room #2 in alternation. Therefore, the two ballasts supply two bulbs in room #1 and two bulbs in room #2 in alternation. The power supply sequency of the bulbs is determined by the timer. At “ON”, the controller directs the power of the ballasts toward the room #1 (bulbs LAMP 1 and 3). At “OFF” the controller directs the power of the ballasts toward the room #2 (bulbs LAMP 2 and 4).
BACK SCHEME / SCHÉMA DOS
Chacun des ballasts alimente une ampoule de la salle #1 et une ampoule de la salle #2 en alternance. Ainsi, les deux ballasts alimentent deux ampoules de la salle #1 et deux ampoules de la salle #2 en alternance.
TIMER / MINUTERIE
La séquence d’alimentation des ampoules est déterminée par la minuterie. À «ON», le contrôleur dirige la puissance des ballasts à la salle #1, soit les ampoules LAMP 1 et 3. À «OFF» le contrôleur dirige la puissance des ballasts à la salle #2, soit les ampoules LAMP 2 et 4.
12hrs «ON» 12hrs «OFF»
Bulbs supply sequency according to the timer / Séquence d’alimentation des ampoules en fonction de la minuterie Timer / Minuterie BALLAST #1 #2
ON ROOM /SALLE
#1 Lamp 1 Lamp 3
OFF ROOM /SALLE
#2 Lamp 2 Lamp 4
THE MOST USED CONFIGURATION / LA CONFIGURATION LA PLUS UTILISÉE Most of the time the four ballasts operate 24hrs/24 whereas the timer is set for two rooms in blooming period, therefore for 12hrs “ON” and 12hrs “OFF”. Therefore, each room benefit of 12 hours of consecutive light followed by 12 hours of darkness. Règle générale, les quatre ballasts fonctionnent 24 heures sur 24 tandis que la minuterie est réglée pour deux salles en période de floraison, soit pour 12 heures «ON» et 12 heures «OFF». Ainsi, chacune des deux salles profite de 12 heures de lumière consécutive suivies de 12 heures de noirceur.
The FLIP20 controller is used to connect 20 lights to 10 ballasts which share the operating time. On one side (front scheme), the sixteen standard connection ...
Le contrôleur FLIP16 sert à connecter 16 ampoules à 8 ballasts qui se partagent le temps d'utilisation. D'un côté (schéma face), les seize bornes standards de ...
Attaching the towline release system . ...... on the B-risers, simply release them a little again until the wing is again ..... from Helmut Reichmann from the book.
Sep 1, 2009 - 4-channel amplifier user manual v.1.1 revision 1 SEPTEMBER 2009 ... information retrieval system, or translating, in whole or in part, without the prior ..... standards leads ecg amplifier module . ..... carrier and the provider.
Oct 27, 2006 - The power of RegiStax sits in the usage of Wavelets. ..... same position as the output pixel under consideration, and the eight surrounding that.
The data and statements contained within this manual may be changed ... part of these documents may be copied or transmitted for any purpose in any ...... PACKING AND CHECKING OF THE RESCUE SYSTEM. .... the very high standards we set ourselves. ....
turbulence and gusting winds can lead to a partial or complete collapse of the .... pulleys (sewn on tabs) in such a way that they allows the pilot to maximize the ..... re-open spontaneously from closures of up to 70% with a change of direction of .
Oct 27, 2006 - RegiStax will go through all the frames for every alignmentpoint and we will ..... If that value is, say, 40%, then it means that frames with a quality.
Nothing is more important than your time and money. When you buy radios online ... Our promise: to give you the best shopping experience. Strong partnerships ...
Read the entire manual carefully before using the HDM97Pocket . ⢠Keep the ...... Delivery Content. Pos. Description. Version. Standard Option. 1. HDM97Pocket meter BL, BM, BN, BO, BP, BQ. â .... meter will accept the probe in the future.
including the associated memory cards, to ensure the video reception and recording are working .... Improper operation will cause the device to crash. ○ Don't ...
Reinforcement of the leading edge and trailing edge: Polyester/Mylar 25 mm .... value of Polar Curves and will be better able to understand the importance of.
Improper disposal may endanger the environment or cause personal injury. ... Refer all communications to the nearest Ingersoll Rand Office or distributor.
utiliza una herramienta motorizada puede provocar una lesión corporal grave. Utilice un equipo de seguridad. Utilice siempre protección ocular. El uso de ...
8 déc. 2015 - accessible for test gauge connection, ..... Insert the tab of the terminal block cover ... dryer frame to the neutral conductor at the terminal block.
En este caso, tanto la base como la llave deberán estar desconectadas del auricular. 11. ...... mark and logos are owned by the Bluetooth SiG, inc. and any use.
For additional information, refer to Cordless Impact Wrench Safety Manual Form 04581146, Battery Charger Safety Information Manual. Form 10567832 and ...
operate (during this procedure, the machine's fan and motors are operating). 5. Use the ... In general, when the fan output is increased the snowflakes produced ...
ventilation, allow a free air space of at least 20 cm around the sides and top of the unit. â¢Never aim the output ... you choose, do not allow the unit to have more than a 25 degree angle of inclination. Z-1200II ... Technical Specifications. Model
User manual. MIDI/Audio control surface with motorized fader for production ..... plus, en appuyant sur la touche « Master », le fader se retournera pour contrôler.
If your shaver does not come with a fet Clean System, it refers ... Note: If there is a protective foil on the display, remove it before you use the shaver for the first ...